Geonworks
VENOM 60 HE PCB
Pickup available at Yu Li Industrial Building
Usually ready in 24 hours
Product Features
- Web-based firmware (https://venom.how/)
- RISC-V32 architecture applied
- Supports 8KHz polling rate / 14KHz scan rate per key
- 0.16ms latency
- Custom PCB standard specifications
- Daughterboard and JST connector included
Product Malfunction CheckPoints
- Use USB 2.0 high-speed or higher A TO C cable
- USB hub not recommended
- Use Chrome browser
- Initialize USB driver
- Firmware upgrade or factory reset
Compatible Switches
- RAPTOR HE
- RAW HE
- GATERON KS-20 / KS-20T, etc.
- N-pole switch, 1600gs or less at bottom magnetic force
Compatible Stabilizers
- PCB mounted (without wire)
Custom Keyboard Assembly Requirements
- VENOM HE PCB
- HE compatible plate
- HE compatible switches
- Compatible housing
- PCB mounted wire-free stabilizers
PCBs
Venom HE 60% 6.25U PCB
Type : Hall effect
Material : FR4
Thickness : 1.6mm
Venom HE 60% 7U PCB (Tsangan Layout)
Type : Hall effect
Material : FR4
Thickness : 1.6mm
Compatible Switches
RAW Hall Effect Switches
Keep in mind
PCB does not include a JST cable and screws.
Plates include screws compatible with Venom PCBs.
All products are made in the size of GH60, which is the standard in the custom keyboard sector.
Before you start assembling the PCB, please carry out a PCB test and check if all keys function.
Before assembling the screws, remove the yellow tape on the stand-offs of PCBs.
Whether or not to use foam sets is optional.
To assemble the PCB and the plate, you must use all 8 screws.
After removing the C-type port once, you cannot put it on again.
Remove the daughter board installed above the arrow keys before usage, since electricity may go through.
Daughter board and C-type ports are made of FR-4, which means you must use a nipper. If you use tools made for other uses such as scissors, the product may be damaged.
QC Standards
PBTfans Keycap QC Standard: Link
Some UV products will exhibit wear over time, which is considered normal due to the UV printing. Furthermore, slight misalignment of the UV pattern is possible, and absolute center alignment or perfection cannot be guaranteed.
Disclaimer
1. The keyboards are for visual illustration purposes and are not a part of this set.
2. These keycaps are semi-transparent; therefore, renders could illustrate inaccurate colour, surface texture, and degree of transparency.
3. The inner layer for the actual set would potentially have visible holes.These holes are not defects but manufacturing constraints from the double shot injection moulding process.
